
NADCA-certified attic HVAC duct cleaning in Ogden, Utah
Attic Duct Cleaning Ogden UT for cleaner, safer air
Attic Duct Cleaning Ogden UT removes the rodent droppings, insulation dust, and mold spores that collect in the ductwork above your ceiling. If your house smells musty after the furnace kicks on, or you have seen droppings near the attic registers, we can help. We serve homeowners across Weber County with HEPA-filtered equipment and same-week scheduling.
What's included
What our attic duct cleaning includes
Every attic duct cleaning service Ogden includes the core steps below. Add-ons like flex replacement, coil cleaning, and dryer vent service are quoted separately if the inspection shows they are needed.
Full attic duct inspection
Video inspection camera run through every accessible trunk and branch, with photos of rodent damage, torn flex, disconnected joints, and mold growth. You get a written summary before we start work.
Mechanical cleaning of all runs
Rotary brush, duct brush system, and air whip applied to each accessible run, with a negative air machine and HEPA vacuum capturing everything we loosen. Includes register boot cleaning and cover removal.
Sanitizing of contaminated ducts
EPA-registered sanitizing solution applied through a fogger to any run that showed mold growth or animal waste. We treat the metal trunk and any flex we are keeping, then let it dry before reassembly.
Joint sealing and insulation check
Duct sealant and mastic applied to every accessible joint, plus an insulation check around the ducts to catch gaps that cause condensation. This is the step that prevents mold from coming back next winter.
Filter replacement and walkthrough
New HEPA filters installed, register covers replaced, and a walkthrough with the technician so you can see the camera footage and ask questions. Payment is collected after the walkthrough, not before.
Service overview
What Attic Duct Cleaning Ogden UT really involves
Attic Duct Cleaning Ogden UT is the process of opening every accessible attic trunk line and branch run, then mechanically scrubbing and vacuuming the interior back to bare metal or clean flex. We start with a video inspection camera to map the layout and spot rodent entry points, then run a rotary brush and air whip through each run while a negative air machine keeps dust from drifting into your living space. Loose debris, insulation fibers, and dander go into a HEPA vacuum, and we finish with a sanitizing fogger on any run that showed mold growth or animal waste.
Ogden attics take a beating. Summer attic temperatures push past 140 degrees, which bakes flexible duct and dries out the inner liner until it cracks. Winter brings the opposite problem: cold attic air meets warm duct surfaces and condensation feeds mold growth in ducts. Add the rodent infestation in ductwork that follows the fall cold snap, and you get the musty odors, dust buildup, and high energy bills from clogged ducts that bring most Ogden homeowners to us. If you have been searching for attic duct cleaning near me Ogden UT, this is the work we do every week.
The service timeline
Our attic duct cleaning process, step by step
The process flexes to the condition, but these checkpoints keep decisions clear.
Inspection and mapping
We start in the attic with a video inspection camera and photograph every trunk line, branch, and register boot. You get a written rundown of what we found: rodent damage, torn flex, disconnected joints, or mold. This takes about 30 minutes and tells us exactly what the job needs.
Containment setup
Before any brush touches a duct, we seal the registers in your living space and set a negative air machine with HEPA filtration at the main trunk. That keeps attic dust, insulation particles, and rodent debris from drifting down into your kitchen and bedrooms while we work.
Mechanical cleaning
We run a rotary brush and duct brush system through each accessible run, then follow with an air whip and compressed air nozzle to knock loose the caked-on dust that brushing alone misses. Everything pulled out goes straight into the HEPA vacuum. Flexible duct that is torn or soaked gets replaced with new insulated flex.
Sanitizing and sealing
Runs that showed mold growth or animal waste get treated with sanitizing solution through a fogger, then we reseal every joint with duct sealant and mastic. We also check the attic insulation around the ducts and flag any gaps that are letting cold air hit warm metal.
Verification and walkthrough
We re-run the camera through the main trunk so you can see the result, replace the register covers, and restore your filters. Before we leave, we walk the attic with you, show you the photos, and explain what to watch for. Payment is due when the work is done, not before.
Tools & methods
Equipment and methods we use
Purpose-built equipment, used by trained technicians, so the job is done accurately the first time.
Rotobrush rotary brush system
Mechanically scrubs the interior wall of each attic run, lifting the caked dust layer that a vacuum alone leaves behind. The flexible shaft reaches deep into branch runs.
Air-Care air whip
Uses compressed air to scour the duct interior from multiple angles at once. We run it after brushing to catch debris the brush pushed into corners and joints.
Abatement Technologies HEPA vacuum
Captures everything we loosen, including fine insulation fibers and rodent debris, so nothing escapes into the attic or your living space during the job.
Nikro negative air machine
Maintains negative pressure on the duct system while we work, which keeps attic dust from being pulled into the supply stream when the blower is off.
Video inspection camera
Documents the interior of every accessible run before and after cleaning. You see the footage, and so do we, which is how we verify the job is actually done.
Sanitizing fogger
Applies EPA-registered sanitizing solution evenly to duct interiors that showed mold growth or animal waste, reaching surfaces a spray bottle cannot.
Goodway duct cleaning accessories
Specialty brushes and nozzles sized for the smaller branch runs common in Ogden attic layouts, where a full-size rotary head will not fit.
Use cases
When Ogden homeowners call us for attic ducts
These examples show how the service framework adapts rather than forcing every call through one repair.

Mold growth cleared in a South Ogden split-level
A 1979 split-level had visible dark growth on the attic duct liner near the plenum. The upstairs smelled damp whenever the heat ran, and one family member had started reacting to the air. → We cleaned the affected runs, applied sanitizing solution, and corrected the insulation gap that was causing condensation. Post-cleaning camera footage showed clean duct walls, and the damp smell did not return.
Dust-choked trunk restored in Riverdale
A duplex near Riverdale had never had its attic ducts cleaned. The main trunk held roughly an inch of packed dust and construction debris from a 1990s remodel, and the back bedroom never reached the thermostat setting. → Mechanical brushing and an air whip cleared the trunk and both branch runs. Airflow at the back bedroom register improved noticeably, and the furnace runtime dropped enough that the owner noticed the difference on the next bill.
Problems we solve
Attic duct problems we fix in Ogden
Most attic duct calls fall into a handful of categories. Here is what we see most often and how we handle each one.
Rodent infestation inside attic ductwork
We remove contaminated flex, bag it in the attic, scrub and sanitize the metal trunk, and seal the entry points rodents used. New insulated flex goes back in, and we document the repair with photos.
Mold growth in ducts from condensation
We locate the wet section with a video inspection camera, clean the growth out, apply sanitizing solution, and correct the insulation gap causing the condensation. Fixing the moisture source is what keeps mold from returning.
Dust buildup choking airflow
Mechanical brushing plus an air whip clears the caked layer that a vacuum alone cannot move. After cleaning, we measure airflow at the registers so you can see the improvement rather than take our word for it.
Torn or disconnected flexible duct
We replace torn flex with new insulated duct, reconnect and seal every joint with duct sealant, and check the attic insulation around the repair so the new run is not sitting in a cold gap.
Pricing process
What attic duct cleaning costs in Ogden
$400 - $1,200 depending on scope
Number of duct runs
Each accessible branch run adds time and equipment passes. A three-run ranch home cleans quickly, while a two-story with eight or more runs takes most of a day. This is the single biggest driver of price.
Rodent damage and flex replacement
If flex liner is soaked or chewed, it has to come out and new insulated duct goes in. Material and labor for replacement typically adds $150 to $400 depending on how many runs are affected.
Attic accessibility
A walk-in attic with a full deck is fast to work in. A tight scuttle with no flooring slows everything down and requires more careful containment, which adds labor time.
How much does attic duct cleaning cost in Ogden UT?
Most Ogden attic duct cleaning jobs run $400 to $1,200 in 2026, depending on how many runs you have and whether rodent damage means replacing flex. A single-trunk ranch home sits at the low end. Larger two-story homes in Ogden Heights with long branch runs and contaminated insulation land higher. You get a flat quote after the attic inspection, before any work starts.
Why do attic ducts get dirty in Ogden Utah?
Three local reasons. Summer attic heat above 140 degrees dries and cracks flexible duct liners, letting insulation fibers inside. Winter condensation on cold duct surfaces feeds mold growth. And the fall rodent push sends mice and pack rats into attic insulation, where they nest against the ductwork and leave droppings. Add ordinary household dust, and attic runs soil fast here.
Can attic HVAC duct cleaning remove rodent smells in Ogden?
Yes, when the contaminated material is removed rather than just vacuumed. Rodent urine soaks into flex liner and insulation, so we cut out the affected sections, bag them in the attic, and replace them. The metal trunk gets scrubbed and treated with sanitizing solution. Most customers notice the musty smell is gone within a day of the cleaning.
How often should attic ducts be cleaned in Ogden UT?
Every three to five years for a typical Ogden home, and sooner if you have pets, a recent rodent problem, or visible dust blowing from registers. Homes near construction or with older flex duct benefit from a camera check every two years. If you smell musty air when the furnace starts, do not wait for the calendar.
Ready when you are
Book Attic Duct Cleaning Ogden UT this week
We are licensed, insured, and NADCA-certified, and we quote the job before we start. Call (855) 927-7517 or request an estimate online and we will get you on the schedule, usually within the same week.

Talk with the local team
Request Attic Duct Cleaning
We answer the phone from 8 a.m. to 6 p.m. Monday through Friday, and the line stays open around the clock for emergency duct calls. Most quotes take under ten minutes on the phone if you know your square footage and how many registers you have. If you would rather we come look, we will schedule a walkthrough at no charge.

